라펜트│카페│블로그│더보기
아카데미 홈 명사특강 대학연구실탐방 조경실무 동영상강의 한국의 전통정원 학회별 논문
학회별 논문

한국건설관리학회
한국건축시공학회
한국도로학회
한국생물환경조절학회
한국생태학회
한국수자원학회
한국식물학회
한국실내디자인학회
한국자원식물학회
한국잔디학회
한국조경학회
한국지반공학회
한국하천호수학회
한국환경생물학회
한국환경생태학회

한국지반공학회 / v.19, no.2, 2003년, pp.237-246
현장타설말뚝의 정재하시험에 의한 지지력과 이론식에 의한 지지력과의 비교
( The Bearing Capacity Comparison of Drilled Shaft by the Static Load Test and the Suggested Bearing Capacity Formulas )
천병식;김원철;최용규;서덕동; 한양대학교 공과대학 토목공학과;한양대학교 공과대학 토목공학과;경성대학교 건설·환경공학부;한양대학교 공과대학 토목공학과;
 
초 록
항타말뚝은 진동과 소음같은 환경적인 문제점이 있다. 특히 대상 토질이 자갈, 호박돌, 풍화암으로 구성되어있다면 항타말뚝의 적용은 불가능하기 때문에 우리나라에서는 현장말뚝의 적용이 증가하고 있는 추세이다. 일반적으로 이론적인 공식에 의한 현장타설말뚝의 지지력은 과소하게 산정되는 것으로 알려져 있다. 본 연구에서는 기존에 제안된 국내외 지지력 산정식과 현장시험을 통한 실측데이터를 비교하기위해 광안대로와 수영 3호교의 암반에 근입된 현장 타설말뚝에 대한 정재하시험을 수행하였으며, 현장타설말뚝의 주변마찰력을 측정하기 위하여 변위계를 설치하였다. 현장시험을 통한 현장타설말뚝의 거동은 반복하중 재하시 완전한 탄성거동을 보였으므로 이는 실제말뚝의 극한지지력에 도달하지 못하였음을 입증한다. 이때 측정된 말뚝의 지지력이 이론식에 의하여 산정된 지지력보다 크게 산정되었다. 또한 실험에서 측정된 결과에 의하면 현장타설말뚝의 주된 지지력이 선단지지력이 아닌 주변마찰저항에 의한 것이라는 것을 보였다. 그리고 이와같은 결과에 의거하여 현장타설말뚝의 설계에 대한 몇가지 제안들을 도출하였다.
The driven pile has environmental problems such as vibration and noise. Especially, if the site consists of gravel, cobble and weather rock, the driven pile can not be applied. Therefore, the application of the drilled shafts is increasing in Korea. However, the bearing capacity values by the suggested theoretical formulas are generally considered too conservative. In this paper, static load tests for the rock socketed drilled shaft at Gwangandaero and Suyeong3hogyo are performed and in order to estimate the side friction of the shaft, strain gauges are applied. The bearing capacities from the field test data and the bearing capacity values by the theoretical formula are compared. Even the static load tests didn't reach to the ultimate bearing capacity condition, and all the measured bearing capacity values were higher than those by the theoretical formulas. The field data also showed that the major bearing capacities were not due to end bearings but side friction resistances. Based on the above results, several suggestions are proposed for the drilled shaft design.
 
키워드
Drilled shaft;Static load test;Strain gauge;Ultimate bearing capacity;
 
한국지반공학회논문집 / v.19, no.2, 2003년, pp.237-246
한국지반공학회
ISSN : 1229-2427
UCI : G100:I100-KOI(KISTI1.1003/JNL.JAKO200311921640880)
언어 : 한국어
논문 제공 : KISTI 한국과학기술정보연구원
목록보기
회사소개 광고안내 이용약관 개인정보취급방침 책임의 한계와 법적고지 이메일주소 무단수집 거부 고객센터
   

하위배너이동