라펜트│카페│블로그│더보기
아카데미 홈 명사특강 대학연구실탐방 조경실무 동영상강의 한국의 전통정원 학회별 논문
학회별 논문

한국건설관리학회
한국건축시공학회
한국도로학회
한국생물환경조절학회
한국생태학회
한국수자원학회
한국식물학회
한국실내디자인학회
한국자원식물학회
한국잔디학회
한국조경학회
한국지반공학회
한국하천호수학회
한국환경생물학회
한국환경생태학회

한국지반공학회 / v.19, no.5, 2003년, pp.35-47
변형봉 센서 검증실험에 관한 연구
( A Study on the Verification Test for a Deformable Rod Sensor )
김상일;최용규;이민희; (주)상지엔지니어링 건축사사무소;경성대학교 건설·환경공학부;부산대학교 대학원 토목공학과;
 
초 록
내부를 콘크리트로 속채움한 강관합성말뚝에 대한 기존의 하중전이 측정에서는 강관의 변형률만 측정하고 콘크리트의 변형률은 강관과 동일하다고 가정하였으며, 시방서에 규정한 방법으로 구한 강관과 콘크리트의 탄성계수를 이용하여 말뚝구성부재의 응력 및 축하중을 산정하였다. 그러나 강관의 변형률만 측정하여 강관과 콘크리트가 완전합성 거동하는 것으로 산정한 축하중은 실제 하중값과 상당한 차이를 보이고 있어 강관합성말뚝의 거동을 정확히 분석할 수 없었다. 따라서, 강관합성말뚝의 경우 각 구성부재의 변형률을 측정할 필요성이 제기되었다. 본 연구에서는 강관합성말뚝의 구성부재인 강재와 콘크리트의 변형률을 측정하는데 사용할 수 있도록 개발된 변형봉 센서에 대한 검증실험을 수행하였다 변형봉 센서를 사용하여 말뚝축하중을 산정할 경우 콘크리트의 탄성계수는 현장에서 제작한 콘크리트 공시체의 압축강도 시험에서 구하도록 제안하였다. 즉, (0.2∼0.6)f$_ck$의 응력 범위에 해당하는 평균접선기울기를 탄성계수로 사용하도록 제안하였다.
In the conventional axial load transfer analysis for composite piles (i.e., steel pipe pile filled with concrete), it was assumed that the concrete's strain is same as the measured steel's strain and the elastic modulus of the steel and the concrete calculated by formular as prescribed by specification is used in calculation of pile axial load. But, the pile axial load calculated by conventional method had some difference with the actual pile load. So, the behavior of a composite pile could not be analyzed exactly. Thus, the necessity to measure the strain for each pile components was proposed. In this study, the verification test for DRS (Deformable Rod Sensor) developed to measure the strain of each pile component (i.e., the steel and the concrete) was performed. In the calculation of pile axial load using the DRS, elastic modulus of concrete could be determined by the uniaxial compression test for the concrete cylinder samples made in the test site and an average tangential modulus in the stress range of (0.2∼0.6)f$_ck$ was taken.
 
키워드
Average tangential modulus;Composite pipe pile;DRS (Deformable Rod Sensor);Elastic modulus;Pile axial load distribution;
 
한국지반공학회논문집 / v.19, no.5, 2003년, pp.35-47
한국지반공학회
ISSN : 1229-2427
UCI : G100:I100-KOI(KISTI1.1003/JNL.JAKO200311921979047)
언어 : 한국어
논문 제공 : KISTI 한국과학기술정보연구원
목록보기
회사소개 광고안내 이용약관 개인정보취급방침 책임의 한계와 법적고지 이메일주소 무단수집 거부 고객센터
   

하위배너이동